Knobs, Hand Wheels & Handles

This handle is used for the back gear shifting mechanism on the mini lathe.

This is the handle that engages the half nuts.

This hand wheel is used on the saddle drive and the tailstock of the mini lathe.

The hand wheel is 90 mm in diameter. It mounts on a 8 mm shaft, with a set screw. The length through the bore is 22 mm. There is an M8 threaded hole for a handle.

This is the handle used on the saddle drive hand wheel and the tailstock hand wheel. It includes the knob, an M8x55 screw and an M8 locking nut.

This knob is used on the high/low speed shifter of both the mini lathe and the mini mill and on the Z-axis coarse feed on the mini mill.

Speed Control Knob

This is the handle that locks the tailstock quill.

This is the handle that clamps the tool post in position.